Installing the Rolling Jackass on a Eunorau Cargo Bike
Put a little grease on the first few threads of all hardware to prevent galling of the threads.
Remove the stock kickstand and clip the zip ties holding the cables on the underside of the boom tube.
Hold the centerstand up to the underside of the frame and start threading the M10 x 20 bolt through the kickstand plate into the centerstand base finger tight.
Place the rectangular aluminum bar over the top of the boom tube and slip the two M6 bolts through it, through the holes in the centerstand base, and tighten the matching nuts finger tight.
Make sure the centerstand base is sitting square to the frame, and that no cables or wires are being pinched between the base and frame, and fully tighten all three bolts.
Route the actuation cable housing along the frame, retaining with zip ties, and install the lever on the handlebars. The lever should be installed in a location that allows it to be pulled all the way to the bar, without interference. This photo shows the G20 equipped with a shift lever, which fits nicely on the open area to the left of the display.
Actuate the stand by pulling on the lever, and pull the bike back and up onto the stand. Take note of the elevation of the tire which has been lifted off the ground. Too high and it will be difficult to set the bike onto the stand, especially when loaded. Too low, and the bike may be unstable when parking on uneven or soft ground. Aim for about 1/2” by adjusting the threaded feet. Lock the feet in place by tightening the jam nuts against the leg with a 9/16” wrench.
Double check that the cable tension is sufficient to actuate the stand. When the lever is pulled all the way to the handlebars, the feet of the stand should be touching the ground. If not, there is a barrel adjuster on the lever, and one at the base of the stand that will allow you to fine tune the cable tension.
The stand is now ready for use!